User's Manual

& User
AN-80i
Manual
70-00072-01-07 Proprietary Redline Communications © 2010 Page 74 of 106 Sept 18, 2008
Table 36: CLI - set
PTP
PMP
Parameter/Description
√
antgain: Enter value for antenna gain (dBi).
When DFS is enabled, it is important that the Antenna Gain setting matches
the true antenna gain. If the antenna gain is set higher incorrectly, the AN-80i is
less sensitive to detecting interference, and is not
operating in compliance with
the UK/ETSI standard.
√
atpc: Enable or disable the ATPC function. Both AN-80i units monitor Rx signal
and automatically adjust the Tx level of the transmitting system to optimize
system performance. The ATPC feature must be enabled on both ends of the
link.
off - Disable
on - Enable
This mode can be changed only if allowed by the options key. If the options key
does not allow changes: 1) value is specified by the options key, 2) executing a
set command for this field will generate an error message.
√
√
autoscan: Enable or disable the Autoscan function.
off - Disable
on - Enable
When enabled, the PTP Subscriber (system mode) AN-80i automatically scans
available channels to locate the current operating frequency of the PTP Sector
Controller system. Executing a set command this field on a PTP Sector
Controller will generate an error message.
√
bsporten: Sector controller Ethernet port enable.
<id> - [id number]
<mode> - <on/off>
√
√
buzzer: Enable or disable the audible alignment buzzer.
off - Disable
on - Enable
When enabled, the rate of the tone is proportional to the receive signal strength
(faster = stronger signal).
√
√
chwidth: Enter the channel bandwidth in MHz. Valid entries are 10, 20, and 40.
√
congid: Connection's group ID.
<id> - [id number]
<gid> - <gid>
√
conlid: Connection's Link ID.
<id> - [id number]
<lid> - <lid>
√
conpri: Connection priority.
<id> - [id number]
<pri> - <VLAN priority>
√
convid: Connection VLAN ID.
<id> - [id number]
<vid> - <VLAN ID>
√
conviden: Connection VLAN enable.
<id> - [id number]
<mode> - <on/off>