User's Manual

& User
AN-80i
Manual
70-00072-01-07 Proprietary Redline Communications © 2010 Page 77 of 106 Sept 18, 2008
Table 36: CLI - set
PTP
PMP
Parameter/Description
√
maxdst: Maximum distance to a subscriber [Km].
<distance> - Maximum distance from SC to SS [Km].
√
√
maxtxpower: Enter the Tx power level (dBm).
This setting is for the transceiver output only. The actual EIRP depends on the
gain of the connected antenna. See section 7: Appendices for a list the
maximum transmit power setting based on the antenna gain for a series of
frequency settings. The maximum value for this field is determined by the
options key.
√
mgmtag: Management VLAN enable.
<mode> - [on | off]
√
mgmvid: Management VLAN ID.
<vlan_id> - <VLAN ID>
√
mrate: Enter the maximum uncoded burst rate (Mbps). Entry values are
dependant on the channel bandwidth (chwidth).
10 MHz: 3, 4.5, 6, 9, 12, 18, 24 or 27
20 MHz: 6, 12, 18, 24, 30, 36, 48, or 54
40 MHz: 12, 24, 36, 48, 60, 72, 96, or 108
The maximum value for this field is determined by the options key.
√
√
netmask: Enter the IP netmask.
√
√
noisethreshold: Enter the maximum noise threshold (-104 dBm to -65 dBm). If
the measured noise (or interference) level exceeds this threshold, the
equipment stops transmitting until the noise level is lower than this threshold.
√
√
optionskey: Enter the options key string.
<kIdx> - Index of the options key [0 | 1]
<kStr> - [<options_key_string>]
√
peermac: Peer MAC address.
<id> - [id number]
<mac> - <MAC address>
√
pllm: Enable or disable prioritized low latency mode;
off - Disable
on - Enable
√
√
radio: Enable or disable the radio transmitter.
off - Disable
on - Enable
√
ratedif: Enter the number of modulation levels to step down during re-
transmission of errored wireless packets. The level can be set from 0 to 7
(recommended value = 2).
√
regper: Frames number between registrations.
<frames> - The number of frames between registrations [4..100].
√
√
rffreq: Enter the center frequency for the RF channel. When operating multiple
links in close proximity, channel frequencies should be separated by a
minimum of the channel size to minimize interference. For example, when
operating in with 20 MHz channels, the separation must be greater than 20
MHz.
√
√
snmp: SNMP enable setting.
off - Disable the SNMP agent.
on - Enable the SNMP agent.