User's Manual

& User
AN-80i
Manual
70-00072-01-07 Proprietary Redline Communications © 2010 Page 82 of 106 Sept 18, 2008
5.3.18 Snmpcommunity
Use the snmpcommunity command to configure SNMP community permissions.
Table 38: CLI - snmpcommunity
PTP
PMP
Description
√
√
add: add a new snmp community to the snmp community table. The
index value is assigned automatically. Up to eight community entries can
be entered in the table.
snmpcommunity add <name> <string> <Enter>
snmpcommunity add <rights> 0 | r | w | rw <Enter>
Where.
0 (zero):Deny read and write permission.
r: Grant read access permission only. Deny write permission.
w: Grant write access permission only. Deny read permission.
rw: Grant read and write access permission for this community.
default: Set all snmp parameters to factory default settings.
snmpcommunity default <idx> <Enter>
del: Delete the specified community entry.
snmpcommunity del <idx> <Enter>
print: List all SNMP communities and associated permissions.
snmpcommunity print <Enter>
5.3.19 Snmptrap
Use the snmptrap command to configure the SNMP trap message reporting.
Table 39: CLI - snmptrap
PTP
PMP
Description
√
√
add: add a new snmp trap to the snmp trap table. The index value is assigned
automatically. Up to eight settings can be entered.
snmptrap add <ipaddr> <port> <community> <Enter>
change: Modify the specified snmp setting.
snmptrap change <idx> [-p <port>] [-i <ip_add>] [-c <community] <Ent>
del: Delete the specified snmp setting.
snmptrap del <idx> <Enter>
print: List all SNMP trap settings.
snmptrap print <Enter>
5.3.20 Test
Use the test command to load the current edited (but not permanently saved)
configuration settings.
Table 40: CLI - test
PTP
PMP
Parameter/Description
√
√
config - AN-80i configuration settings
test config <Enter>