User manual

RDL-2000 User Manual
70-00143-01-01 Proprietary Redline Communications © 2011 Page 44 of 52 March 9, 2011
5 CLI Interface
This section describes the RDL-2000 operations available when using the Command
Link Interface (CLI) over a Telnet Connection. All commands are ca se-sensitive. The
user is not required to login for basic access.
Note: The CLI does not support all features necessary to configure and operate the RD-
2000. Use the Link Manager applications to deploy and monitor the RDL-2000 units.
The following table contains a summary of available CLI commands.
Table 8: CLI -Command Summary
Master
Slave
Command
Description
√
aes
Activate/deactivate AES (encryption)
√ √
atpc
Set ATPC mode and power level
√
autorate
Activate/deactivate auto rates
√
extsync
Set/show ext/GPS sync (not supported in this release)
√ √
firmware
Upgrade firmware
√ √
help, ?
Show all available commands
√
id
Set/show id (MAC address format)
√ √
ip
Set/show IP
√ √
logger
Activate/deactivate Ethernet logger
√
mgmtvid
Set/show Mgmt VLAN tag
√ √
power
Set/show tx power
√ √
pwd
Set password
√ √
quit
Exit shell
√
rate
Set/show peer downlink/uplink rates
√ √
reset
Reset unit and exit shell
√ √
rssi
Activate/deactivate RSSI collection
√ √
rtext
Show last reset text
√
set
Set/show link peer with this MAC address
√ √
sweep
Perform spectrum sweep
√ √
switchbank
Switch firmware banks and reset
√
update
Program non volatile flash with parameter changes
√ √
[user pass]
Login to modify parameters
Chapter 5
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]