Installation Manual

RDL-2000 User Manual
70-00143-01-01a Proprietary Redline Communications © 2010 Page 48 of 50 September 20, 2010
Chapter
6
6 Reference Information
Table 10: Reference - RDL-2000 Technical Specifications
System Capability: LOS, optical-LOS, and non-LOS (OFDM)
RF Band: 4.940 to 5.850 GHz
1
,
6
TDD, 2x2 MIMO
Channel Size: 5, 10, 20, and 40 MHz (software selectable)
1
Center Freq. Steps: 5 MHz
1, 2
Max Tx Power: 22 dBm
1, 3
(-22 dBm min.)
Rx Sensitivity: -95 dBm (BPSK)
Data Rate: 300 Mbps wireless data rate
4
PoE Cable: Up to 91 m (300 ft)
5
Network Attributes: Transparent bridge
DHCP pass-through
Modulation: BPSK to 64 QAM
Bi directional dynamic adaptive
Dynamic Control: DFS, ATPC:
MAC: PTP, Fast ARQ (Automatic Retransmit)
IIS (Intelligent Interference Sensing)
ACM (Adaptive Coding & Modulation)
FEC (Forward Error Correction)
Fragmentation, Concatenation
System Configuration: Telnet,
Link Manager Application (Windows-based)
Network Connection: 2x 10/100 Ethernet (RJ-45)
PoE Cable: Up to 91 m (300 ft)
5
Wireless Encryption: AES-128
Operating Temp: -35 C to 60 C
Power Consumption: Max 6 W, PoE
Power Supply: 110/220/240 VAC 50/60 Hz
Compliance: Safety: IEC, and EN 60950
EMC: EN 301 489-1, EN 301 489-17
RF: FCC: part 15
Industry Canada: RSS 210
ETSI: EN 302 502, EN 301 893
1
Restricted by regional regulatory certification: ETSI 5.4-5.8 GHz, FCC/IC 5.8 GHz, Other 5.4-5.8 GHz
2
Center frequency is dependent on region.
3
Maximum power based on modulation and coding.
4
Actual Ethernet data throughput is dependent on factors including: protocols, packet size (1916 bytes
max.), burst rate, transmission latency, and link distance.
5
Total distance from RDL-2000 port to PoE port.
6
Determined be factory installed hardware.
All specifications are subject to change without notice.