User's Manual

RDL-2000 User Manual
70-00143-01-01a Proprietary Redline Communications © 2010 Page 40 of 50 September 24, 2010
Chapter
4
4 Troubleshooting
4.1 Reset Text Messages
The following table lists causes that may be logged in the Reset Text description. This
description includes the duration of uptime (seconds) since the previous reboot.
Table 5: Maintenance - Reset Text
DFS Detected
Master detected DFS.
DFS Detected by SU
Master received DFS detection message from Slave
and switched channel.
Link type changed
Change mode between Master/Slave.
Reset text cleared by PC
Link Manager has sent command to clear the Reset
Text field (Action->Clear Reset Text).
Reset text corrupted
The RDL-2000 has been power cycled.
Resetting the unit to perform ACS
User selected Perform ACS.
Scan stopped
Spectrum sweep stopped by operator.
Scanning watchdog expired
Slave will reboot automatically every three minutes
while in scanning mode (searching for Master).
Signal lost
Slave has switched to scanning mode.
Telnet reset command
Reset command from Telnet.
4.2 Reset Causes
The unit will perform a (normal) reset when the following operating parameters are
modified:
Table 6: Maintenance - Causes of System Reboot
Operation
Cause(s)
AES mode
Operator action
1
.
Channel
Operator action
1
, license file
2
, DFS action
3
.
Channel BW
Operator action
1
, license file
2
.
DFS mode
Operator action
1
, license file
2
.
MIMO mode
Operator action
1
.
MU ID
Operator action
1
.
RF Band
Operator action
1
, license file
2
.
Fixed Frame Mode
Operator action
1
1. Operator has changed a parameter setting.
2. Operator has loaded a new license file.
3. DFS action has changed channel.