User's Manual

RDL-2000 User Manual
70-00143-01-01a Proprietary Redline Communications © 2010 Page 42 of 50 September 24, 2010
Chapter
5
5 CLI Interface
This section describes the RDL-2000 operations available when using the Command
Link Interface (CLI) over a Telnet Connection. All commands are case-sensitive. The
user is not required to login for basic access.
Note: The CLI does not support all features necessary to configure and operate the RD-
2000. Use the Link Manager applications to deploy and monitor the RDL-2000 units.
5.1 CLI Command Summary
The following table contains a summary of available CLI commands.
Table 8: CLI -Command Summary
Master
Slave
Command
Description
√
aes
Activate/deactivate AES (encryption)
√
√
atpc
Set ATPC mode and power level
√
autorate
Activate/deactivate auto rates
√
extsync
Set/show ext/GPS sync (not supported in this release)
√
√
firmware
Upgrade firmware
√
√
help, ?
Show all available commands
√
id
Set/show id (MAC address format)
√
√
ip
Set/show IP
√
√
logger
Activate/deactivate Ethernet logger
√
mgmtvid
Set/show Mgmt VLAN tag
√
√
power
Set/show tx power
√
√
pwd
Set password
√
√
quit
Exit shell
√
rate
Set/show peer downlink/uplink rates
√
√
reset
Reset unit and exit shell
√
√
rssi
Activate/deactivate RSSI collection
√
√
rtext
Show last reset text
√
set
Set/show link peer with this MAC address
√
√
sweep
Perform spectrum sweep
√
√
switchbank
Switch firmware banks and reset
√
update
Program non volatile flash with parameter changes
√
√
[user pass]
Login to modify parameters