User's Manual

RDL-2000 User Manual

Table 9: CLI - Command Summary

Current power = 15 dBm

pwd <new_pswd> <new_pswd>

Change the password of the current user (must be logged-in)

new_pwd - Enter the new password twice (second entry is for confirmation).

Password changes are saved immediately and do not require the update command.

Example: Change password to Az123:

[192.168.25.2] >>: pwd Az123 Az123

quit

Exit from this Telnet session.

Important: If required, save parameters before exiting (see update command). All

unsaved changes are discarded.

Example: Exit from this session:

[192.168.25.2] >>: quit

Connection to host has been lost.

rate <dl_rate> <ul_rate>

View or modify the RDL-2000 downlink and uplink rates.

Rate settings are: 0 = BPSK 1/2, 1 = QPSK 1/2, 2 = QPSK 3/4, 3 = 16 QAM 1/2, 4 = 16

QAM 3/4, 5 = 64 QAM 2/3, 6 = 64 QAM 3/4, and 7 = 64 QAM 5/6

dl_rate: Enter the desired maximum downlink modulation/coding for the link. When

Adaptive Modulation is disabled, the RDL-2000 downlink rate is fixed at this

modulation/coding. When Adaptive Modulation is enabled, this setting is ignored.

ul_rate: Select the desired maximum uplink modulation/coding for the link. When

Adaptive Modulation is disabled, the RDL-2000 uplink rate is fixed at this

modulation/coding. When Adaptive Modulation is enabled, this setting is ignored.

Example: Set the RDL-2000 rate to downlink = 64 QAM 5/6 and uplink = 64 QAM 2/3:

[192.168.25.2] >>: rate 7 5

reset

Reboot the RDL-2000. The current Telnet session will be closed. Unsaved changes will

be discarded.

Example: Reset the RDL-2000:

[192.168.25.2] >>: reset

Connection to host has been lost.

rtext [clear]

View or clear the recorded cause of the last system reset.

[blank] - Display cause of last reset.

clear - Delete the cause of the last reset.

Example: Clear the cause of the last reset:

[192.168.25.2] >>: rtext clear

rssi [clear]

View or enable/disable the RSSI collection settings.

[blank] - Display current mode/setting.