User's Manual

RDL-3000 User Manual

RF Port 2 & 1: The RF transmitter is operating in MIMO mode (both ports enabled).

Transmitting on port 2 and listening on ports 1 and 2.

Apply: Click to accept and activate the wireless settings displayed on this screen.

Apply & Save All: Click to permanently save the wireless settings displayed on this

screen. These settings will be restored on power-up, reboot, or at the end of a test cycle.

Note: Clicking on another main menu item before clicking Apply or Apply & Save All will

discard any changes made to settings displayed on the current screen.

Frequency Management Screen

Click Configuration->Wireless->Frequencies to display the Frequency Management

screen. Up to 32 frequency ranges may be entered. Settings entered on the sector

controller are automatically downloaded and used by subscribers with the Auto Scan

feature enabled. This screen is identical for the sector controller and subscriber units.

Click to expand or to hide fields.

Fig. 46: Web - Frequency Management Screen

PMP SC

The sector controller can be programmed with a master list of frequency ranges. When a

subscriber registers with the sector controller, this list is automatically downloaded to the

subscriber and displayed as the Remote Frequency Ranges. Subscribers with Auto

Scan enabled use these downloaded range settings exclusively. These settings remain

in effect until the subscriber is rebooted, at which time the settings are erased.

PMP SS

When no frequency ranges are entered, the subscriber scans all available frequency

ranges for that region to locate a sector controller. If all frequency ranges are scanned

three times without detecting and registering with a sector controller, the subscriber is

gin scanning the entire frequency band enabled by the options key. Frequency ranges

downloaded from the sector controller, or programmed manually, are scanned as the

first priority. Downloaded ranges are deleted when the subscriber is rebooted.