User's Manual

RDL-3000-RMG PRODUCT MANUAL
70-00184-04-01 Proprietary Redline Communications © 2013 Page 36 of 39 May 16, 2013
STATE
CITY
LONGITUDE
LATITUDE
FREQUENCY
TERRAIN
ELEVATION
(MSL) [ft]
ANTENNA
HEIGHT
ABOVE
TERRAIN
[ft]
TX
HOUSTON
INTERCONTL
W 095 34 01
N 30 03 54
5605 MHz
154
97
TX
PEARLAND
W 095 14 30
N 29 30 59
5645 MHz
36
80
Additional information:
http://spectrumbridge.com/udrs/home.aspx
http://www.wispa.org/?page_id=2341
5.1.2 Industry Canada Notices
Deployment in Canada
This Class B Digital apparatus meets all the requirements of the Canadian Interference-
Causing Equipment.
The following notices about deployment in Canada are included in training and
documentation provided to professional installers and operators of the final product:
1. The final product must be professionally installed.
2. WARNING -- IC RF Exposure Warnings
To satisfy IC RF exposure requirements for RF transmitting devices, the following
distances should be maintained between the antenna of this device and persons
during device operation:
Table 67: IC: RDL-3000-RMG Recommended Safe Distances
Frequency (MHz)
Deployment
Separation Distance
4900
PMP
260 cm (103") or more
5300
PMP
20 cm (7.8") or more
5400
PMP
20 cm (7.8") or more
5800
PMP
20 cm (7.8") or more
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
The RDL-3000-RMG has been designed to operate with an antenna having a maximum
gain of 32 dBi. Antenna having a higher gain is strictly prohibited per regulations of
Industry Canada. The required antenna impedance is 50 ohms.
This device has been designed to ensure that radio frequency emissions are maintained
within the band of operation under all normal operating conditions listed in this manual.
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropic radiated power (EIRP) is not more than
that required for successful communication.