User's Manual

RDL-3000 RMC/E/F MODULE PRODUCT MANUAL

3 Module Installation and Service

3.1 Installation into a Final Product

The module must be installed only by trained professional technicians authorized by

Redline or its agents. The module must be installed only into an approved enclosure

(see Conditions of Use) and only at an approved manufacturing facility or service depot.

Redline shall retain complete control over the final installation of the module and will

ensure compliance of the end product to all applicable FCC/IC regulations. The module

must be installed only into an approved enclosure (see Conditions of Use) and only at an

approved manufacturing facility or service depot.

Redline licensing of the modular transmitter includes monitoring to ensure compliance in

the operation and use of the module as expressly specified within this manual. This

includes restrictions against modification of the module hardware, approval of the final

enclosure, operational restrictions for installers and end-users, and approval of antennas

provided for use with the product.

Operation of the final product requires the 'key' be controlled exclusively by the

manufacturer. The 'key' must be unique to each module and must be installed and

activated before the radio will operate. The key must contain sufficient security features

to the professional installer and operator can not decode, modify, substitute, or

otherwise circumvent the operational restrictions imposed by the 'key'.

The software 'key' must limit the transmit power, operating frequency range, and channel

bandwidth per the regulator domain governing the location where the radio will be

deployed. The operator does not have the option to select the country or regulatory

region of operation.

The software 'key' must limit the mode of operation as a master or client. The client

mode is 'passive listener' and while in this mode the module can not initiate any

transmission without first receiving and decoding a valid authorization message from the

master. A module with a key for client operation can not be changed by the installer to

enable master mode operation.

Redline will review all final products for compliance to regulatory restrictions.

The manufacturer must meet all labeling described in section 2.3.

3.2 Module Servicing

The module is not intended to be field serviceable, and contains no field serviceable or

field replaceable parts. The module must be serviced only at an approved manufacturing

facility or service depot.

Warning: The module is susceptible to damage from electrostatic charge.

Electrostatic Discharge (ESD) must be avoided to prevent damaging or destroying the

module. The module must always be store in an anti-static container/bag prior to

installation and following removal from the product for servicing. Observe ESD

precautions when handling the module.