MCO080103 (801) OWNER/OPERATOR MANUAL BACKPACK SPRAYER BM46I WARNING WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. This sprayer is not designed to be used with acids of any kind, corrosive products like caustic soda, gasoline, materials capable of generating heat, hot fluids, explosive or highly volatile products. USE OF THESE AND OTHERS EXPOSE USERS TO SERIOUS INJURY AND EVEN DEATH.
SAFETY FIRST Instructions contained in warnings within this manual and warning seals marked with a symbol on the sprayer concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. Note that there may be times when warning seals peel off or become soiled and impossible to read.
1. Parts location 4.
. For safe operation 5. Wear sturdy rubber-soled shoes or shoes with some other form of anti-slip protection to help protect you against falling when filling, using and/or cleaning the sprayer. 6. Do not wear loose clothing, scarves, neck chains, hair longer than shoulder length, and the like when filling, using and/or cleaning the sprayer. IMPORTANT Check and follow the local regulations. ■ WORKING PLAN • When planning your work schedule, allow plenty of time to rest.
4. For safe operation • Make sure the spray hose loops freely without kinking or squeezing. 4. After using sprayers and other equipment, CLEAN UP! Dispose of debris in trash receptacles. ■ MAINTENANCE 1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals. 2. Examine the sprayer at intervals for loose fasteners and rusted or damaged parts. Use special care for chemical leakage.
5. Set up NOTE Hose clamps are not completely tight. Please tighten hose clamps prior to using. Hose clamps are left loose to extend life of gaskets and fittings. WARNING Oil cap gasket before using and lubricate weekly so the gasket will seal properly and prevent chemical leaks. Oil check valve and maintain breather hole clear of debris. Your failure to oil may can cause the tank to collapse and crack due to vacuum created by pump lubricate with "3 and 1" oil.
5. Set up locking pin. (See figure 3). The round tube comes through the base of the unit and extends out 6.4mm (1/4”), exposing the hole drilled through the tube. Place on the other washer and the other holding pin. The pump handle assembly is now complete. HIP SUPPORT Take the black plastic hip portion and side the two end sections into the two receiving notches on the base, the rounded side up.
7. Operation • Always release pressure in the pump prior to filling, cleaning, or servicing the sprayer. • Before opening a container of pesticide or other spray material, carefully read, understand, and follow all instructions on the label. • Do not use flammable materials in the sprayer: they can ignite and/or explode, causing serious injury. • Never use caustic or corrosive materials in the sprayer, which could result in damage to the unit.
. Storage WARNING 11. Parts list BACKPACK SPRAYER Never store chemicals in your sprayer for any length of time 1. Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down and squeeze spray pistol (aim away from you). Pressure will escape; when hissing stops, all pressure has been released. Remove pump assembly by turning counterclockwise. The pump handle has two locking positions, one turning clockwise and one counter-clockwise. 2.
11.
. Parts List : BM46I Key# Part KIT Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 RMKIT0571 RMKIT02A RMKIT02CH RMKIT01AS RMKIT15 RMKIT31 RMKIT283 RMKIT36 RMKIT17 RMKIT18 RMKIT19 RMKIT20 RMKIT21 RMKIT367 RMKIT22 RMKIT25 RMKIT24 RMKIT26 RMKIT392 RMKIT140 RMKIT146 RMKIT147 RMKIT182 RMKIT299 RMKIT297 RMKIT141 RMKIT142 RMKIT145 RMKIT0568 RMKIT0569 RMKIT150 RMKIT0570 RMKIT180 RMKIT181 Description Red cap with handle and check valve. • Seal.
LIMITED WARRANTY FOR TWO (2) YEARS OF HOME USE, ONE (1) YEAR FOR COMMERCIAL USE AND NINETY (90) DAYS FOR RENTAL USE FROM THE DATE OF ORIGINAL PURCHASE,THE COMPANY, THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL PURCHASER, ANY PART OF PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP. THIS IS THE EXCLUSIVE REMEDY. THE PURCHASER SHALL BEAR COSTS OF TRANSPORTING THE UNIT TO AND FROM THE RedMax DEALER.
