Specifications

4
maintenance or checking
procedures.
The metallic parts reach high temperatures
immediately after stopping the engine.
3. When replacing the oil or any
lubricant, always be sure to use
only RedMax products or
products which have been
certified by RedMax for use with
the RedMax product.
4. In the event that any part must be
replaced or any maintenance or
repair work not described in this
manual must be performed, contact
a G.E.B.E. representative.
5. Under no circumstances should you
ever take apart the product or alter it
in any way. Doing so might result in
the product becoming damaged
during operation or the product
becoming unable to operate
properly.
_ HANDLING FUEL
1. The engine of the RedMax product
is designed to run on a mixed fuel
which contains highly flammable
gasoline. Never store cans of fuel or
refill the tank of the unit in any place
where there is a boiler, stove, wood
fire, electrical sparks, welding
sparks, or any other source of heat
or fire which might ignite the fuel.
2. Never smoke while operating the
unit or refilling its fuel tank.
3. When refilling the tank, always turn
off the engine and allow it to cool
down. Take a careful look around to
make sure that there are no sparks
or open flames anywhere nearby
before refueling.
4. Wipe spilled fuel completely using a
dry rag if any fuel spillage occurs
during refueling.
5. After refueling, screw the fuel cap
back tightly onto the fuel.
_ TRANSPORTATION
• Never transport the product over
rough roads over long distances by
vehicle without removing all fuel
from the fuel tank. If doing so, fuel
might leak from the tank during
transport.
_ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire
to the joint on the top of the
carburetor. (SE7)
_ CONNECTING SWITCH WIRES
• Connect the switch wires between
the engine and mount. Connect the
wires: Black to Yellow and Red to
Green . (SE7)