Workshop Manual

12
STRATO CHARGED ENGINE GZ25N
6. SERVICE GUIDE
6-6 Assembling of lgnition Coil
Insert the gauge (3350-96240) in between the rotor
magnet metal and the coil. Tighten screws while
pressing the coil against the rotor.
Gap specification 0.3 0.4mm(0.012 0.016in.)
Remove the recoil starter and the spark plug.
Insert the stopper (4810-96220) to the plug hole.
Engage the puller (4500-96100) to 2 holes on
the pulley and pull out the pulley.
Note:
Pulley screw is right turn screw.
6-5 Removing Recoil Pulley
Pulley
Pulle
r
Wrench
Ignition coil
Gauge
6-7 Installing of Spark Plug
The spark plug nut is 16mm hex. so that conven-
tional plug wrench (19mm) cannot be used.
Make sure to use the custom plug wrench.
Important:
Fixing the spark plug using other tools than the
custom plug wrench may apply over torque and end
up with damages of threads on the cylinder.
16mm