Trimmer Owner/Operator Manual

6. Set up

English

■ CUTTERCASE (SE4)

The blade has very sharp edges. Be sure to use

protective gloves whenever handling it.

1. Remove the fastening screw(long) and the lock

screw(short) from the cuttercase.

2. While aligning the locking holes, install the

cuttercase assembly to the shaft casing.

3. Align the locking holes and screw in the lock screw

to the bottom by hand, then secure it with the

wrench provided. Do not tighten up the lock screw

with the holes out of alignment, or the cuttercase can

be damaged.

(1) Cuttercase

(2) Locking holes

If the locking screw is tightened up with the holes out of

alignment, the cuttercase may be damaged.

4. Fasten the cuttercase fastening screw.

■ BLADE GUARD

Install the blade guard onto the shaft casing approx.

3cm away from the cuttercase. Fasten the clamp

uniformly. (SE5, SE6)

NOTE

WARNING

SE6

SE5

SE4