User Manual

Redpine Signals, Inc. Proprietary and Confidential Page 9
User Manual
Version 1.2.1
Band
(GHz)
Bandwidth
(MHz)
Channel
Number
Center Frequency (MHz)
5 20 136 5680
5 20 140 5700
5 20 149 5745
5 20 153 5765
5 20 157 5785
5 20 161 5805
5 20 165 5825
Table 1: Channel Numbers and Corresponding Center Frequencies
<expa>: Enable/Disable External PA. This parameter is not supported in
the current release.
<rf>: Rate Flags. This parameter is used to enable/disable Short GI and
Greenfield and also to set the channel width of the transmitted packets.
The table below explains the flags that can be enabled and disabled.
Multiple flags can be set at a time.
Bit Description
0 Short GI
0 – Disable Short GI
1 – Enable Short GI
1 Greenfield transmission
0 – Disable Greenfield transmission
1 – Enable Greenfield transmission
[4:2] Operating bandwidth of the channel (3 bits)
0 – 20MHz
2 (Bit 3 is set) – NA
4 (Bit 4 is set) – NA
6 (Bits 3 and 4 are set) – NA
Table 2: Rate Flags for Transmit Tests
<aggr>: Enable/Disable Aggregation. Enter 0 to disable aggregation and
1 to enable aggregation. The packet length is divided into chunks of size
1792 bytes and aggregated. This parameter applies only to the Burst
mode transmission and is ignored in the case of Continuous mode of
transmission.