User Manual

Redpine Signals, Inc. Page 14
Connect
-
io
-
n™
RS9110-N-11-24
Evaluation Board User Guide
V
V
e
e
r
r
s
s
i
i
o
o
n
n
3
3
.
.
1
1
3
3
3.2 Configure Serial Port Monitor in the PC
The actual bytes exchanged between the module and the Host PC may
not all be readable on Hyperterminal or Teraterm because of ASCII
conversion. A serial port monitor
2
can be used to see the actual bytes. A
free package is available at http://www.serial-port-monitor.com/ , while
other similar software such as Hterm, Docklight etc. also provide good
interfaces to simultaneously view ASCII and actual bytes exchanged in
the UART interface. The following sections assume that HHD Free Serial
Port Monitor has been installed from the above link.
Open the “HHD Free Serial Port Monitor” BEFORE opening the
Hyperterminal or Teraterm. Click on File -> New Session. Select “Serial
Port Monitor”. Select the appropriate COM port and “Request view” for
the display format.
2
Redpine Signals Inc. assumes no liability for damages of any kind resulting from
use of third party software.