User Manual

Redpine Signals, Inc. Page 36
Connect
-
io
-
n™
RS9110-N-11-24
Evaluation Board User Guide
V
V
e
e
r
r
s
s
i
i
o
o
n
n
3
3
.
.
1
1
3
3
Figure 8: Wireless Configuration Set-up
1. Power up the module. The module sends the message – “Firmware
upgrade (y/n)”. Send ‘s’ to the module. The module sends two
options: 1.Configuration Firmware upgrade
2.Load Configuration Firmware
2. Press ‘2’. The module now becomes an Access Point with open mode
and SSID REDPINE_<last 3 bytes of MAC ID of the module>.
3. Connect a Laptop (C) to the AP created by the module. The Laptop
should be configured as a DHCP client. The Laptop will acquire the IP
address from the AP.
4. Open the application
RS.CN.xx.GENR.UT.x.x.x\Software\Wireless_Upgrade\
DeviceConfigGUI.jar in Laptop (C) and click on the connect button.
Leave the “Device IP Address” and “Device Port” unchanged to
192.168.40.61 and 14320 respectively. After clicking on “Connect”
Button, click on the “Configuration” tab on top.
PC
(P)
RS9110-N-11-24
UART
Interfac
Laptop (C)