User Manual

Redpine Signals, Inc. Page 49
Connect
-
io
-
n™
RS9110-N-11-24
Evaluation Board User Guide
V
V
e
e
r
r
s
s
i
i
o
o
n
n
3
3
.
.
1
1
3
3
dev_addr of the network driver on the Host OS. Once this is stored after
association with AP, the user can bring the wlan interface up
In Linux, this is usually done by:
ifconfig wlan0 <ipaddr>
ifconfig wlan0 up
The user can query wlan0 interface status using:
ifconfig wlan0
The Redpine Module’s MAC address should be listed in the HW Addr
(00:23:A7:xx:xx:xx)
Figure 15: Architecture with TCP/IP Bypassed
4.2 SPI Operations
The SPI operations with the TCP/IP stack enabled in the module are
shown below.