Installation Manual

Redpine Signals, Inc. Proprietary and Confidential Page 7

User Manual

Version 2.0.0

6) External PA Enable/Disable

7) Rate Flags like Short GI, Greenfield, etc.

8) Enable/Disable Aggregation

9) Number of packets to be transmitted in Burst Mode

10) Delay between packets in Burst Mode

11) Regulatory Domain

2.1.1 Transmit Command

./transmit

<tpow><rate><len><mode><chan><expa><rf><aggr><num><delay

><reg>

2.1.2 Transmit Command Description

The command usage is explained below.

<tpow>: Transmit power in dBm for controlling transmit power. To set

the transmit power value, enter a value either between -7 and18.If a

value of 127 is entered, the packet will be transmitted at the maximum

power from the Transmit power table in the module.

<rate>: Transmit Data Rate. To set the transmit data rate, select a value

from 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, 54, mcs0, mcs1, mcs2,

mcs3, mcs4, mcs5, mcs6 and mcs7.

<len>: Transmit packet length in bytes. Enter a value between 24 and

1536 when aggregation is not enabled and between 24 and 30000 when

aggregation is enabled.

<mode>: Transmit mode. Enter 0 for Burst mode and 1 for Continuous

mode.

<chan>: Transmit channel number. The following table maps the channel

numbers to the center frequency for 20MHz bandwidth modes in 2.4GHz

and 5GHz band.

Band

(GHz)

Bandwidth

(MHz)

Channel

Number

Center Frequency (MHz)

2.4 20 1 2412

2.4 20 2 2417

2.4 20 3 2422

2.4 20 4 2427

2.4 20 5 2432

This is not supported in the current release.