User Manual

10
RS9113
PHY Evaluation Test Utility
User Guide for Linux
After starting this application, user has to enter the following command to
stop the ongoing transmission:
# ./transmit <m>
<m> - 0 for Burst Mode
1 for Continuous Mode
Set power value:
To set Tx gain value, enter a valid value for <p> parameter. The valid
values are from 229 to 255 for RS9113 module. The transmit power
increases proportionately with increase in Tx gain value in OFDM and CCK
modes. This support is not present in this release.
Set Data Rate:
To set transmit data rate, enter a valid rate for <r> parameter.
Valid values are (1,2,5.5,11,6,9,12,18,24,36,48,54,mcs0, mcs1, mcs2,
mcs3, mcs4, mcs5, mcs6, mcs7).
Set Packet Length:
For setting the transmission packet length, enter a valid value for <l>
parameter.
Valid values are in the range of 24 and 1500.The values are in bytes.
Set Transmit Mode:
For setting the transmission mode, you need to enter one of the following
values for <m> parameter.
1 for continuous mode
0 for burst mode.
Set Channel number:
For setting the channel number in 2.4 GHz you need to enter a value in
the range 1 –11 for <c> parameter. The following tables map the channel
number to the actual radio frequency in the 2.4 GHz spectrum for 20MHz
channel width.