User Manual

6
RS9113
PHY Evaluation Test Utility
User Guide for Linux
2 Test Setup Details
The diagram shown below, illustrates the test setup for evaluating receive
and transmit performance of RS9113™ WLAN module.
As shown in the test setup, the RS9113™ evaluation board (EVB) is
plugged into Linux based laptop either on the SDIO slot via SDIO
connector or USB port via USB cable through port J6 on the EVB. The
board is connected to a WLAN signal analyzer through a microwave
coaxial cable to test the Tx performance.
Figure 1: Linux Based RF Evaluation Setup With USB Interface