Quick start Guide

MOUNTING NAKED GoPro

FOR GoPro

HERO3

1. Loosen screws (A) slightly and lower

Bottom Plate. It is not necessary to remove

screws or bottom plate completely.

2. Install Top Insert as shown. Secure from top of

cage with screws (B).

3. Place Bottom Insert into groove at bottom of cage.

Tighten screw (C) from bottom insert into bottom plate.

4. Push camera into place in cage, flush with front surface.

Guides on the cage will locate camera. Tighten screws (A).

5. Install any GoPro accessories then install L Bracket. Tighten screw

(D) as shown.

1. Loosen thumbscrew, slide up

Top Locking Bracket and

tighten.

2. Position GoPro Waterproof

Housing Accessory Feet into

cage as shown.

3. Once in position, push camera

into place, upright in cage. Slide

Top Locking Bracket down and

tighten thumbscrew.

MOUNTING HOUSED GoPro

http://start.redrockmicro.com

TUTORIALS AND CUSTOMER SUPPORT

GOPRO® & HERO® are trademarks or registered trademarks

of Woodman Labs, Inc. in the United States and other countries

*Requires the optional Deluxe Accessory Kit

PAGE 1
FOR GoPro HERO3 B 2 4 D 5 MOUNTING HOUSED GoPro 1. Loosen thumbscrew, slide up Top Locking Bracket and tighten. 2. Position GoPro Waterproof Housing Accessory Feet into cage as shown. 3. Once in position, push camera into place, upright in cage. Slide Top Locking Bracket down and tighten thumbscrew. 1 C GOPRO® & HERO® are trademarks or registered trademarks of Woodman Labs, Inc. in the United States and other countries 3 A 1 MOUNTING NAKED GoPro *Requires the optional Deluxe Accessory Kit 1.