Owner's Manual

7
3
28
27
27
28
31
31
2
2. See the inset drawing. Orient the Large Foot
(19) as shown, and attach it to the Frame (3) with
t
wo M4 x 16mm Screws (25).
O
rient the Frame Extension (5) and the Frame (3)
as shown. Attach the Frame Extension to the
Frame with two M8 x 70mm Bolts (30), two M8
Washers (28), and two M8 Nylon Locknuts (27).
Do not tighten the Nylon Locknuts yet.
3. Attach the Frame Extension (5) to the Crossbar
(2) with three M8 x 80mm Bolts (31), three M8
Washers (28), and three M8 Nylon Locknuts (27).
Do not tighten the Nylon Locknuts yet.
2
28
28
3
0
3
0
2
7
4. Set the ends of the Backrest Rod (14) in a set of
brackets on the Uprights (1, 4). Make sure that
the pins on the Backrest Rod are fully inserted
into the holes in the brackets.
See steps 1 to 3. Tighten the M8 Nylon Locknuts
(27).
4
1
14
Pin
Hole
Hole
Pin
4
3
3
5
19
25
28
5
Wide
End