Manual

Safe-T-Reel Welding Hose Reels
Page 2
www.reelcraft.com
INSTALLATION INSTRUCTIONS
Inspection
Unpackandinspectreelfordamage.Turnthereelbyhandtocheckforsmoothoperation.Checkforcompleteness.
Figure 1
Figure 2
Figure 3
Mounting of the hose reel
1. Four 1/2” diameter mounting holes are located at the base of the reel. Mount reel using four (customer supplied) bolts;
tightening them securely to ensure a solid, rigid attachment. (Figure 1)
Connecting the inlet hose
1. Apply thread compound to all threads.
2. Threadmaleconnectorofsupplylineinto90°elbowlocatedatthebackofthereel.Tightensecurely.(Figure2)
Connecting the outlet hose
1. Apply thread compound to all threads.
2. Threadmaleconnectorofhoseinto90°elbowlocatedwithinthespool.Tightensecurely.(Figure3)
CAUTION:
Fully extend and charge hose before winding onto reel. Momentarily open control valve, when initially charging to purge hose of
gases.Whenfluidappearsatcontrolvalve,closevalve.Thispreventsflatteningofthehoseandexcessivepressureonthedrum
when fluid supply is reinitialized at a later time.