Owner's manual

Installation Instructions:

1. Mount reel to secure structure directly above

work. NOTE: Disregard this step if reel is pre-

mounted to Torq-Arm or other equipment.

(Figure 1a and 1b)

2. Raise tool and attach to hook on end of cable.

CAUTION: Do not pull cable down. It is spring

loaded and could cause injury if allowed to snap

back. (Figure 2a and 2b)

3. Be sure tool is securely hooked to cable. Do not

drop tool. Tool may be heavier than spring can

lift before spring is adjusted. (Figure 3)

TB 01 TB 03 TB 05

Operating Instructions

Series TB Tool Balancers

Model Numbers:

Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725

Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605

Customer Service: 855-634-9109 • reelcraft@reelcraft.com • www.reelcraft.com

Rev: 8/2013

Dimensions

Figure 1a

Figure 1b

Figure

Figure 3

Safety Clip - 261241

Bright zinc plated steel cable

and safety latch for tool

attachment and other uses.

Measures 2.375” (60 mm)

long. Included with each

model.

PAGE 1
Operating Instructions Series TB Tool Balancers Model Numbers: TB 01 TB 03 TB 05 Dimensions Safety Clip - 261241 Bright zinc plated steel cable and safety latch for tool attachment and other uses. Measures 2.375” (60 mm) long. Included with each model. Installation Instructions: Figure 1a 1. Mount reel to secure structure directly above work. NOTE: Disregard this step if reel is premounted to Torq-Arm or other equipment. (Figure 1a and 1b) Figure 1b 2.
PAGE 2
Series TB Tool Balancers 4. Determine ideal height for tool when tool is not in use. (Figure 4) Figure 4 Figure 5 5. Slide ball stop up or down cable to hold tool at determined height. Keep a minimum of 3 inches between ball stop and end of cable. (Figure 5) 6. To INCREASE spring tension, turn “palm knob” clockwise until tool rises to ball stop. (Figure 6) 7. To DECREASE spring tension, repeatedly depress button on top of the reel. (Figure 7) Figure 7 8.