Instruction Manual

Operating Instructions
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: [phone]
Customer Service: 855-634-9109 • [e-mail] • www.reelcraft.com
Series WC7000 Welding Cable Reels
Model Numbers:
WC7000 WCH7000
Read this manual carefully before installing, operating or
servicing this equipment.
IMPORTANT
Four 1/2” diameter mounting holes
Dimensions
WC7000 WCH7000
A 20 1/4” 20 1/4”
B 19 3/4” 19 3/4”
C 7 7/8” 7 7/8”
D 3 7/8” 3 7/8”
E 13 1/4” 14”
• Ensure that only a qualified electrician installs/services this
equipment.
• Ensure that power supply voltage does not exceed maximum
voltage rating of reel.
• Ensure that reel is properly installed before connecting to power
supply.
• Ensure that all electrical power is removed from reel before
servicing.
• Check for frayed/broken wires before each use.
• Pull electrical cord from reel by grasping the electrical cord
itself, not the work device.
• If an electrical malfunction should occur, remove power from reel
immediately.
• Ensure that reel, electrical cable, and equipment being serviced
are properly grounded. Use an ohmmeter to check ground
continuity.
• If reel ceases to unwind or rewind, remove power immediately.
Do not pull or jerk on electrical cable!
• Treat and respect the cable reel as any other piece of machinery,
observing all common safety practices.
WARNING: Even low voltage can cause irreparable damage or
death! Exercise extreme caution while operating or servicing this
equipment.
WARNING: This reel is to be used for cable storage only! The
entire length of cable must be unwound before use. Severe
damage to the reel will result if the cable is energized while fully
wound on the reel.
SAFETY
Personal injury and/or equipment damage may result if proper safety
precautions are not observed.
Form# 1154-304 Rev: 10/2018