User manual

38
10. Commissioning
a) Inserting Batteries in the Transmitter
Open the battery compartment at the bottom of the transmitter, push the battery compartment lid out forwards (ob-
serve the arrow on the battery compartment lid). Insert two new batteries type AA/Mignon. Observe correct polarity
(plus/+andminus/-),seelabelonthebatterycompartmentofthetransmitter.Closethebatterycompartmentagain.
Due to the lower voltage of rechargeable batteries (example: AA/Mignon battery = rated voltage 1.5 V,
AA/Mignon rechargeable battery = rated voltage 1.2 V), the operating time will be shorter, since the transmit-
ter will report a too-low voltage rather soon.
 Ifyouwanttouserechargeablebatteriesinthetransmitteranyway,werecommenduseofNiMHrecharge-
able batteries with a low self-discharge.
b) Removing the Car Body
The car body is attached to the car by 4 clips; see circle
marksinthegureontheright.
Pull the clips out and carefully take the car body off up-
wards.
Ifthereisasafetylmonthecarbody,removeit.
c) Inserting the Rechargeable Batteries into the Vehicle
Important!
This vehicle is exclusively suitable for use with two Li-Ion rechargeable batteries of type "18650" (rated volt-
age 3.7 V). Never use any other rechargeable batteries or batteries in the vehicle.
Firstswitchoffthevehicle(forpositionoftheslider,seethe
arrowinthegureontheright,"O"=off).
To insert the two rechargeable batteries, remove the two
covers on the left and right of the vehicle; they are only
connected by clips.
Insert the two rechargeable batteries in the correct polar-
ity(observeplus/+andminus/-;seelabelsinthebattery
compartment).
Clip on the covers again.
Figure 2
Figure 3