User manual

d) Taking the Transmitter into Operation

• First,putthetwotrimcontrollers"STEERINGTRIM"(gure1,item5)and"THROTTLETRIM"(gure1,item7)into

the middle position.

• Checkiftheslider"STEERINGREV."(gure1,item8)isintheposition"N".

• Switchonthetransmitter.ThentheredLED(gure1,item6)startstoashquickly.Nowtakethevehicleintoopera-

tion; see next section.

e) Taking the Vehicle into Operation

• Leavethethrottle/brakelever(gure1,item3)atthetransmitterinitsneutralposition(donottouch/movethelever).

• Switchonthetransmitterifyouhaven’tdonesoalready;observechapter10.d).

• Placethevehicleonanappropriatesurfacesothatthewheelscanturnfreely.Neverreachintothedrive,anddo

not stop the wheels with your hand.

• Nowswitchonthevehicle.Movetheslider(seecirclein

thegureontheright)intotheposition"I"(=on).

• TheredLEDonthereceiver/controllerunitandthered

LEDatthetransmitterashquickly.

 Afterafewseconds,bothLEDsshouldstopashing;the

transmitter and receiver are now connected.

The vehicle is now ready for operation and will react to

the control commands at the transmitter.

 TheredLED(gure1,item6)atthetransmitterashesquicklyduringthesearchforthereceiverinthe

vehicle. When the transmitter has recognised the receiver in the vehicle, the LED will remain lit.

 IftheLEDsarestillashingquicklyafter10seconds,switchoffthetransmitterandthevehicle.Thenswitch

on the transmitter and then the vehicle again.

 IftheredLEDinthetransmitterashesslowly,thebatteriesinthetransmitterareweakandmustbere-

placed by new ones.

• Ifthevehiclemotorstartseventhroughyoudidnotmovethethrottle/brakeleveratthetransmitter,setthetrimwith

thetrimcontroller"THROTTLETRIM"(gure1,item7)sothatthemotorstops.

• Thetrimcontroller"STEERINGTRIM"(gure1,item8)forthesteeringshouldbeinthecentreposition.Forthis,the

wheels are in parallel with the vehicle chassis. The trim controller for the steering is set precisely later when running

the vehicle.

f) Attaching the Car Body

Now put the car body onto the vehicle and attach it by the 4 clips removed at the start.

Figure 4