User manual

10. Programming the Speed Controller

a) Programming of Neutral and Full Throttle Positions

If the vehicle does not stop calmly in the neutral position of the throttle/brake lever, you can correct the trimming for

the driving function at the transmitter.

Ifthetrimpathisnotsufcient(orifthetrimisalreadyalmostattheendofthetrimpath)youcanreprogramtheneutral

position and the full throttle positions for forward/reverse driving.

Proceed as follows:

• Switchonthetransmitter,butleavethethrottle/brakeintheneutralposition.Putthetrimmingfordrivingintothe

centre position.

• Keepthesetupbutton(2)pressedandturnthespeed

controller on („ON“).

• The LED ashes at the speed controller then ashes

red; the motor emits bleeps. Release the setup button

again.

If you do not release the setup button, the programming

mode is activated after a few seconds (see chapter 10.

b). In this case, switch off the speed controller and pro-

ceed again as described above.

• Releasethethrottle/brakeatyourtransmittersothatitsitsintheneutralposition.

• Shortlypushthesetupbutton(2).TheLEDatthespeedcontrollerashesgreenonceandabeepisemitted.The

neutral position is now saved.

The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, depen-

ding on the motor. In this case, observe the LED on the speed controller.

• Movethethrottle/brakeleveratthetransmittertofullthrottleforforwardsdriving,pullittowardsthehandleandhold

it there.

Attention!

If you do not move the transmitter throttle/brake lever during the programming process or do not move it

far enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become

uncontrollable. In that case, repeat programming.

• Shortlypushthesetupbutton(2).TheLEDatthespeedcontrollerashesgreentwiceandtwobeepsareemitted.

The full throttle position for forward driving is stored.

• Movethethrottle/brakelevertofullthrottleforreversedriving,pushitawayfromthehandletothestop.

• Shortlypushthesetupbutton(2).TheLEDatthespeedcontrollerashesgreenthriceandthreebeepsareemitted.

The full throttle position for reverse driving is stored.

• Releasethethrottle/brakesothatitsitsintheneutralposition.

• Nowwaitforatleast3seconds.Thesettingmodeisleftautomaticallyandthespeedcontrollerisreadyforoperation

with the new settings made.



OFF ON