User manual

• Neverchargethebatteryrightafteruse.Alwaysleavetherechargeablebatteriestocooloffrst(atleast5-10

minutes).

• Neverplacethechargerandrechargeablebatteryonaheat-resistant,inammablesurface.

• Chargerandrechargeablebatteriesheatupwhencharging.Leaveenoughdistancebetweenthechargerandthe

rechargeable battery, never place the rechargeable battery on the charger. Never cover the charger and the battery.

Do not expose the charger and rechargeable battery to any high/low temperatures or to direct solar radiation.

• Neverleavebatteriesunattendedwhilechargingthem.

• Neveruseatoo-highchargingcurrent.Observethemanufacturerinformationonidealormaximumchargingcur-

rents.

• Removethebatteryfromthechargerwhenitisfullycharged.

• Chargesandrechargeablebatteriesmustnotgetdamporwet.Thereisadangertolifefromelectricshock;there

alsoisadangerofreandexplosionfromtherechargeablebattery!

• Observetheoperatinginstructionsforthechargerusedbeforechargingthebattery.

b) Receiver Battery

• Useahigh-current-capable5-cellNiMHHumpbatterypackforpowersupplyforthereceiverandthetwoservos

(nominal voltage 6.0 V, capacity at least 1300 mAh recommended, with BEC connection).

Conventional battery cannot deliver any high currents as they are needed e.g. for the steering servo. Therefore

never use batteries for the power supply of the receiver and servos.

• Disconnectthereceiverbatteryfromthereceiverbeforechargingandremoveitfromthevehicle'sbatterybox.