User manual
22
11. Commissioning of the Quadrocopter
Before you start the quadrocopter for the rst time, read this section with care. Only if you are absolutely
certain that you have made all settings correctly must you start the motors and let the quadrocopter lift off.
Otherwise, contact an experienced model pilot who can support you in initial commissioning. We recom-
mend using a ight simulator where you can train your rst ight tasks without danger.
a) Checking Activation/Deactivation function of the Flight Battery
Before inserting the ight battery in the quadrocopter, check the activation/deactivation function of the electronics in
the ight battery.
Switching on
To switch on the ight battery, briey push the on/off button (1)
at the ight battery and release it again at once. When the ight
battery is fully charged, the four LEDs of the ight battery will
start to light up.
Now push the on/off button (1) again and keep it pushed. The
four LEDs will go out and start to light up again in sequence
(LED 1 to LED 4).
When all four LEDs are lit, release the button again. The ight
battery is now on and voltage is pending on the rechargeable
battery contacts.
Switching Off
Briey push the on/off button (1) at the ight battery with the
ight battery switched on and release it again at once. The four
LEDs of the ight battery will start to ash three times.
During this time, push the on/off button (1) again and keep it
pushed. The four LEDs will be lit and then go out in sequence
(LED 4 to LED 1).
When LED 1 has gone dark as well, release the button again.
The ight battery is now off and the battery contacts are powe-
red down.
Figure 15
Figure 14