User manual

34
When the „IOC“ function has been activated, the movement directions of the quadrocopter no longer refer to its build.
The movement direction of the quadrocopter changes depending on which mode is called within the „IOC“ function.
Important!
The „IOC“ function requires concurrent reception of more than 6 GPS satellites and the quadrocopter must
be more than 5 m away from the starting point. Then, a total of three modes are available:
„CL Mode“ (= „Course Lock“)
„HL-Mode“ (= „Home Point Lock“)
„POI-Mode“ (= „Point Of Interest“)
Attention!
When the quadrocopter is in „IOC-Mode“ and ies farther away, do not push the „IOC“ switch repeatedly
since this will overwrite saved values and, e.g, the „return home“ point will be in an entirely different location
(also see chapter 13).
d) „CL-Mode“
In „CL-Mode“ (= „Course Lock“), the quadrocopter uses its installed compass to measure its alignment. When the
quadrocopter has been aligned e.g. with a far-distance church tower with its front before the start, it will always y
towards the church tower when steering forward at the transmitter. This applies even if the quadrocopter has been
turned around during the ight and its front points in any other direction.
Figure 26