User manual

45
22. The System Setting Menu „System Setup“
The basic settings of the remote control transmitter are made in
the system setup menu rst.
To get to the system settings menu, push the button „OK“ with
the transmitter switched on. The operating display in the display
switches to the menu display. The selection window around the
remote control icon shows that you can call the „System Setup“
menu in this setting.
Briey push the button „OK“ again to get to the system settings
menu.
The 5 menu items of the system setting menu are now dis-
played.
The following setting functions are available for you in the system setting menu:
Function Display
Control stick assignment „Sticks mode“
Display brightness „LCD brightness“
Transmitter software version „Firmware ver.“
Transmitter software update „Firmware update“
Factory reset „Factory reset“
a) Control Stick Assignment „Sticks mode“
As already described in chapter „Commissioning of the Quadrocopter“, the two control sticks are assigned specic
control functions. The channels transmitted by the transmitter have the following functions:
CH1 = channel 1 (roll function)
CH2 = channel 2 (nod function)
CH3 = channel 3 (pitch function)
CH4 = channel 4 (yaw function)
When setting the control stick assignment (mode), you can exactly determine the control stick you want to use to
control channels 1 - 4. Ex works, the remote control is congured to „mode 2“.
Figure 35