User manual
46
Setting the Control stick Assignment
• Switch on the transmitter and call the system setting menu.
• The top menu item „Sticks mode“ is marked by the cursor ar-
row.
• Briey push the button „OK“ to activate the menu item.
The display shows the currently used control stick assign-
ment. The two circles with the lines offset by 90° are the two
control sticks. Additionally, the control functions are displayed
according to the control stick assignment.
• Pushing the buttons „UP“ or „DOWN“ permits setting the desi-
red control stick assignment „Mode 1“ to „Mode 4“.
• Keep the button „CANCEL“ pushed for a longer period to save
the settings. The display then shows the system setup menu
again.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
Note:
Any change to the control stick assignment is only possible with
the ight battery disconnected from the quadrocopter.
If the quadrocopter is in operation, the error message that the
receiver must be taken out of operation will be displayed.
Figure 36
Figure 37