User manual
6
5. Product Description
The ready-to-y quadrocopter has 4 separate motors that drive one propeller each. Concurrent acceleration of all
propellers permits the quadrocopter to lift off of the ground and hover stably in the air at the corresponding propeller
speeds.
The enclosed remote control permits controlling the quadrocopter specically to the desired ight altitude and direc-
tion.
The installed GPS receiver enables the quadrocopter to orient itself in the open eld to independently perform com-
plex ight manoeuvres. Another GPS receiver that is connected to the remote control transmitter enables the quadro-
copter to automatically follow the moving transmitter.
To better recognise the alignment of the model in ight, the two arms pointing forward are lit white from below, the ones
pointing back are lit red. The current operating condition of the quadrocopter is displayed with status LEDs.
The enclosed 2.4 GHz radio remote control system may be switched from „Mode 2“ to „Mode 1“ without any great
effort and permits detailed control of the model.
Below the quadrocopter, a camera holder (2D gimbal) that is stabilised around two axes is installed. It may hold action
cams of the GoPro type or corresponding cameras with the same dimensions, and permits a perfectly calm video in
ight.
Legal note:
Observe the legal basics of your country regarding photographs and videos of persons, objects and fa-
cilities, as well as their publication. You alone are taking full responsibility if use of the quadrocopter as a
camera carrier violates any rights, laws or regulations.
Commercial use of the quadrocopter requires a ight permission in Germany.
Also observe applicable provisions under ight law, such as the max. permissible ight altitude or ight
prohibitions for models in direct proximity of airelds or military facilities. Find out in how far these or other
provisions and regulations must be observed and complied with at the planned site of use.
Even though the quadrocopter can y autonomously, you alone are responsible for use of the ight unit.
For operation of the transmitter, 4 AA/mignon batteries (e.g. Conrad item no.: 652506, order 4x) are required.