User manual

g) Switching on the Speed Controller

Switchonthespeed controllerbymovingtheslider(seegureinchapter9.f)towardsthesetupbutton (switch

position „ON“). Then wait for a few seconds (leave the throttle/brake lever on the transmitter in the neutral position;

do not move it).

If the vehicle drive starts although the throttle/brake on the transmitter is in the neutral position, then adjust

the trim on the transmitter until the motor stops.

 Ifthetrimmingpathisinsufcient,theneutralpositionmustbeprogrammed,seechapter10.a).

Now check the drive and steering functions of the vehicle.

For programming the speed controller, please observe chapter 10. b).

Important!

If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether

undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the

LiPo battery will suffer deep discharge and be destroyed.

 IfaNiMHdrivebatteryisused,switchoffundervoltagerecognitionorsetittoalowervaluethanforLiPo

batteries, see chapter 10. b).

The LED at the speed controller goes out in the neutral position or is lit in red when driving forward and backwards.

The LED lights up green when driving forwards and at full throttle.

h) Attach roll-over bar

Foldtheroll-overbardown(rstreinsertthecarbodycorrectlyifyouhaveremovedit).Pushtheaerialtubefromthe

bottom of the car body through the respective opening. Fasten the roll-over bar with the four safety clips that were

removed initially.

i) Controlling the Vehicle

Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.

Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too fast at

the beginning until you get used to the car‘s reactions. Do not make any quick and jerky movements with the operating

elements of the remote control.

Never point the transmitter aerial directly onto the vehicle. It will strongly decrease the range. The maximum range will

be achieved when the aerial of the transmitter and vehicle are both vertical and in parallel to each other.

If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.

Whenswitchingbetweenforwardandreversegears,thethrottle/brakelevermustbeputintheneutralpositionbriey

(approx. 1 second) (neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward

to reverse directly, the brake function of the drive is activated (vehicle will NOT reverse).

Waitforatleast5-10minutesuntilmotorandspeedcontrollerhavecooleddownsufcientlybeforethenextrun.Only

then start a new drive with a full drive battery.