Safety data sheet

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 205228
Material Safety Data Sheet
Page 1 of 10
1. Identification of the Substance/Preparation and of the Company/Undertaking
Product: Rechargeable Polymer Li-Ion Battery
Manufacturer: Conrad Electronic SE
Nominal voltage: 3,7 V
Nominal capacity: 400 mAh
Address: Klaus-Conrad-Str. 1, D-92240 Hirschau
Telephone: [phone] / 40 - 8988
Date of issue: 17.03.2016
Other means of identification
Synonyms:none
Recommended use of the chemical and restrictions on use
Recommended Use: Used in portable electronic equipments;
a) Do not dismantle, open or shred secondary cells or batteries.
b) Do not expose cells or batteries to heat or fire. Avoid storage in direct sunlight.
c) Do not short-circuit a cell or a battery. Do not store cells or batteries haphazardly in a box or drawer where they may short-
circuit each other or be short-circuited by other metal objects.
d) Do not remove a cell or battery from its original packaging until required for use.
e) Do not subject cells or batteries to mechanical shock.
f) In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made,
wash the affected area with copious amounts of water and seek medical advice.
g) Do not use any charger other than that specifically provided for use with the equipment.
h) Observe the plus (+) and minus (–) marks on the cell, battery and equipment and ensure correct use.
i) Do not use any cell or battery which is not designed for use with the equipment.
j) Do not mix cells of different manufacture, capacity, size or type within a device.
k) Battery usage by children should be supervised.
l) Seek medical advice immediately if a cell or a battery has been swallowed.
m) Always purchase the battery recommended by the device manufacturer for the equipment.
n) Keep cells and batteries clean and dry.
o) Wipe the cell or battery terminals with a clean dry cloth if they become dirty.
p) Secondary cells and batteries need to be charged before use. Always use the correct charger and refer to the
manufacturer’s instructions or equipment manual for proper charging instructions.
q) Do not leave a battery on prolonged charge when not in use.
r) After extended periods of storage, it may be necessary to charge and discharge the cells or batteries several times to
obtain maximum performance.
s) Retain the original product literature for future reference.
t) Use only the cell or battery in the application for which it was intended.
u) When possible, remove the battery from the equipment when not in use.
v) Dispose of properly.