D GB Elektro-Flugmodell „W2000“ ARF Electric Flight Model „W2000“ ARF Best.-Nr. / Item No.
INHALT ANLEITUNG HIGH PERFORMANCE MODELS Sehr geehrter Kunde, vielen Dank für den Kauf einer W2000. Die W2000 ist ein ferngesteuertes Scale-Modell welches durch Detailtreue sofort auffällt. Die äußerst stabilen Flugeigenschaften sorgen dafür dass dieses Modell ideal als Trainer eingesetzt und sehr langsam geflogen werden kann.
BAUANLEITUNG Schritt 1: Montage Motor (Nur für die Kit Version notwendig) Schritt 3: Montage des Landegestells (Notwendig für die ARF-Version) Befestigen Sie das Landegestell mit den beiliegenden M3x16 Schrauben am Rumpf. Die Landegestellabdeckung ist mit doppelseitigem Klebeband versehen. Entfernen Sie den Schutzfilm und kleben Sie die Abdeckung entlang der angegeben Linie fest. Montieren Sie einen passenden Motor mit Hilfe von 4 Schrauben an den Montorspant.
W2000 - fertig zusammengebaut Schritt 5: Montage von Spinner, Propeller und Leitwerkanlenkung Setzen Sie den Propeller auf die Aufnahme am Motor und ziehen Sie die Mutter an. Setzen Sie den Spinner auf und sichern Sie ihn mit den beiliegenden Schrauben. Achten Sie bei der Montage des Propellers auf die Drehrichtung. Die Beschriftung muss in Richtung Flugrichtung zeigen. Hängen Sie die Gabelköpfe im 3. Loch der Leitwerkanlenkung ein. Justieren Sie die Länge, so dass das jeweilige Leitwerk mittig steht.
Sicherheitshinweise Schritt 2: Flugzeug Schwerpunkt Der Schwerpunkt liegt 70mm hinter dem Anfang der Tragfläche (siehe Bild). ● Bringen Sie durch Verschieben des Akkus ihr Flugzeug Erwachsenen. in die richtige Balance. Dieses Modell ist kein Spielzeug. Erst ab 14 Jahren geeignet. Betrieb von Kindern nur unter Aufsicht von ● Bauen Sie dieses Modell strikt nach der Anleitung zusammen und modifizieren Sie es nicht.
Entsorgung Produkt www.conrad.com Elektronische Geräte sind Wertstoffe und gehören nicht in den Hausmüll. Entsorgen Sie das Produkt am Ende seiner Lebensdauer gemäß den geltenden gesetzlichen Bestimmungen. Entnehmen Sie evtl. eingelegte Batterien/Akkus und entsorgen Sie diese getrennt vom Produkt. Elektro Flugmodell W-2000 ARF Best.-Nr.
INTRODUCTION CONTENTS HIGH PERFORMANCE MODELS Dear Customer: Thanks for purchasing W2000. The W2000 is a scale model and has a very outstanding appearance. We are dedicated to making it as scale as possible. So many details are remained. As a trainer, the slat design makes it very stable in low speed. And the soft landing gear mechanism makes it impact-resistant when a hard landing happens. We wish you have a lot of fun with the W2000.
ASSEMBLE THE MODEL Step 1: Mount the motor (Start to assemble Kit version as below) Step 3: Mount the landing gear (Start to assemble ARF version as below) Install the landing gear with 2 pcs M3x16 screws to the fuselage. And peel off the tape film, then attach the yellow cover onto the landing gear. Please fit the cover closely to the outline of fuselage. Mount a proper motor to the motor mount with 4 screws. Guide the motor wires through the hole under the motor.
Assmbled product as shown below Step 5: Mount the spinner,propeller and connect the control horns Fit the propeller to the motor mount and tighten the nut, then install the spinner by tightening the 2 screws. Please be careful of prop orientation. Normally the side with characters faces forward. Lastly connect all clevis to control horn using the third hole on the control horn. Please adjust the clevis to make sure the flap, aileron, rudder and elevator should be centered after connection.
Safety Instructions Section 2:Recommended CG For the first flight,the recommended Center of Gravity location is 70mm behind the leading edge of the wing against the fuselage.Use the battery pack , moving it forward or backward,to achieve the correct balance . ● This model is not a toy. Allowed for children over 14 years. Children under 14 years old must use it accompanied by an adult. ● Assemble the model accordingly to this instruction manual. Do not alter or modify the model.
Disposal www.conrad.com Item no. 1380198 Product Electronic devices are recyclable waste and must not be disposed of in the household waste. At the end of its service life, dispose of the product according to the relevant statutory regulations. Remove any inserted (rechargeable) batteries and dispose of them separately from the product. (Rechargeable) batteries Intended use This product is solely designed for private use in the fieldof model making and the operating times associated with it.