User manual

10. Programming the Speed Controller

a) Programming of Neutral and Full Throttle Positions

If the vehicle does not stop calmly in the neutral position of the throttle/brake lever, you can correct the trimming for the

drivingfunctionatthetransmitter.Ifthetrimpathisnotsufcient(orifthetrimisalreadyalmostattheendofthetrim

path) you can reprogram the neutral position and the full throttle positions for forward/reverse driving.

Proceed as follows:

• Switchonthetransmitterandputthetrimmingforthedrivingfunctionintothecentreposition.

• Movethethrottle/brakeleveratthetransmittertofullthrottleforforwardsdriving,pullittowardsthehandletothe

stop and hold it there (do not release the lever!).

• Switchonthespeedcontroller;bothLEDswillash1xandthemotorwillemitashortbeep.Continuetokeepthe

throttle/brake lever in the full throttle position for forwards driving.

The beeps are generated by a short start-up of the brushless motor.

• Themotorwillemitalongbeepafterapprox.6secondsandthegreenLEDwillash1xbriey;thefullthrottleposi-

tion for forward driving is saved.

• Nowmovethethrottle/brakeleveratthetransmittertofullthrottleforreversedriving,pushitawayfromthehandle

to the stop.

• Themotorwillemitalongbeepafterapprox.3secondsandtheredLEDwillash1xbriey;thefullthrottleposition

for reverse driving is saved.

• Releasethethrottle/brakeatyourtransmittersothatitsitsintheneutralposition.

• ThemotorwillnowemitashortbeepandbothLEDswillash1xbriey,followedbyamelody"Di-Be-Du".The

neutralpositionissaved;thesettingmodeisclosedautomaticallyandthespeedcontrollerisreadyforoperation

with the new settings.

Attention!

If you do not move the transmitter throttle/brake lever during the programming process or do not move it

far enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become

uncontrollable. In that case, repeat programming.