User manual

51
b) Programming the Special Functions
The speed controller is already pre-programmed with the most sensible pre-settings ex works.
If you use rechargeable LiPo batteries for operating the vehicle, you need to switch on the undervoltage
protection (recommended: 3.2 or 3.0 V/cell). With the undervoltage recognition deactivated, the LiPo battery
will suffer deep discharge and be destroyed.
If a NiMH drive battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo
batteries.
Programming is possible very easily via the setup button, two LEDs and the corresponding motor beeps.
The beeps are generated by a short start-up of the brushless motor.
The following setting functions and setting values are available:
The grey values are the basic settings performed by the manufacturer at the time these operating instruc-
tions were drawn up.
Green LED Red LED flashes.... (+ Beep)
flashes....
(+ Beep)
1x short 2x short 3x short 4x short 5x short 6x short
1 Drive function 1x short Forwards/
Brake
Forwards/
Reverse
Forwards/
Brake/
Reverse
2 Max. reverse speed 2x short 20% 40% 60% 80% 100%
3 Brake force 3x short 25% 50% 75% 100%
4 Motor brake 4x short 0% 10% 20% 40% 70% 100%
5 Neutral range 5x short 3% 6% 9% 12%
6 Starting mode 1x long +
1x short
Very fast Fast Normal Slow
7 Timing 1x long +
2x short
0° 5° 10°15° 20°
8 Undervoltage protection 1x long +
3x short
switched off
(NiMH)
2.8 V/cell 3.0 V/cell 3.2 V/cell 3.4 V/cell
9 Overtemperature
protection
1x long +
4x short
90 °C 100 °C off
10 Protection function for
LiPo
1x long +
5x short
Reduce
power
Deactivate
motor
Function