User manual

Proceed as follows for programming:

• Switchonthetransmitterifyouhaven’tdoneitalready.

• Switchoffthespeedcontroller("OFF").

• Keepthesetupbuttonnexttotheon/offswitchpressedandturnthespeedcontrolleron.Themotorwillemitashort

beepandbothLEDsatthespeedcontrollerwillashbrieyandsimultaneously1x.Continuetopushandholdthe

setup button. Don't release it.

• Afterapprox.3seconds,themotorwillemittwolongsounds("Di-Du")andbothLEDsatthespeedcontrollerwill

ashbrieyandsimultaneously2x.

Now release the setup button. Then the speed controller will activate programming mode.

• NowthegreenLEDwillash.TheashesofthegreenLEDshowwhichsettingfunction(1...10)iscurrentlyse-

lected. Note the table on the following page.

• Whenthesettingfunctionthatyouwanttochangeisdisplayed(e.g.function#8=undervoltageprotection,green

LEDashes1xlong+3xshort,themotoremitsonelongand3shortbeeps),brieypushthesetupbutton.

• NowtheredLEDashesandthemotoremitsbeeps.ThenumberofashesoftheredLEDandthebeepsindicate

whichsettingisactive(e.g.function#3=brakeforce,1xash/beep=25%,2xash/beep=50%,3xash/beep=

75%,4xash/beep=100%).

• Whenthedesiredsettingisdisplayed(byashingoftheredLED+beepingofthemotor,e.g.function#3=brake

force,1xash/beep=25%),brieypushthesetupbutton.Thesettingisnowsaved.

• Thespeedcontrollerthenreturnstothefunctionselection(thisisdisplayedbyashingofthegreenLEDandthe

motor beeps).

You can now select another function (1....10) as described above and then change the respective settings.

• Toendprogrammingandsavethesettings,keepthesetupbuttonpushedfor3seconds.Themotorwillemittwo

longsounds("Di-Du")andbothLEDswillashsimultaneously2x.Thespeedcontrollernowsavesallsettings.

 ThenthemotorwillemitanotherlongsoundandbothLEDswillashsimultaneously1x.Savingiscompleted.

Now release the setup button.

• Switchoffthespeedcontrollerandswitchifonagainafterafewseconds.Nowthespeedcontrollercanbeused

with the newly programmed settings.