User manual

55
c) Resetting the Speed Controller
This function will reset all settings that were adjusted when setting up the speed controller unit to the original factory
settings (see grey marker in the table in chapter 10. b).
Proceed as follows:
• Switchoffthespeedcontroller.
• Switchonthetransmitterandmovethethrottle/brakeleverintothefullthrottlepositionforforwarddriving(pullthe
throttle/brake lever all the way towards the handle).
• Whilethethrottle/brakeleverispulledallthewaytowardsthehandle,switchonthespeedcontroller.Continueto
hold the throttle/brake lever. Do not release it!
Wait for 6 seconds. The motor will emit a long beep.
• Keepthesetupbuttonpushedfor3seconds.Themotorwillemittwolongbeeps,followedbyasinglebeep.
• Nowreleasethesetupbutton.Thenreleasethethrottle/brakeleveratthetransmitter.Thespeedcontrollerhas
restored the basic settings.
• Forreprogrammingofthespeedcontroller,observechapter10.a)and10.b).
d)StatusMessages(LED/beepviamotor)
• Intheneutralposition,noLEDatthespeedcontrollerislit.Themotorisstandingstill.
• ThegreenLEDwillashquicklywhendrivingforward.
• TheredLEDwillashquicklywhenreversing.
• TheredLEDwillremainlitwhenbraking.
• Whentheoverheatingprotectionofthevehiclehastripped(ifitisswitchedoninthesetup),thegreenLEDwillash
and the motor will emit a beep every two seconds.
• Whenthedrivebatteryisatandtheundervoltageprotectionofthevehiclehastripped(ifitisswitchedoninthe
setup),theredLEDwillashandthemotorwillemitabeepeverysecond.
• Whenthespeedcontrollerdoesnotrecogniseanyvalidsignalfromthetransmitter,theredLEDwillashandthe
motor will emit two beeps every second.
This may be different if the receiver used has its own failsafe function. Observe the separately enclosed
operating instructions for the remote control system.
• WhenbothLEDsashatthesametimeandthemotorbeeps,thespeedcontrollerhasnotproperlyrecognisedthe
neutral position.