User manual

j) Controlling the Vehicle

Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.

Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too

quickly at the beginning until you get used to the car's reactions. Do not make any quick and jerky move-

ments with the operating elements of the remote control.

 Thefollowingguresareonlytoillustratethefunctionsanddonotnecessarilycorrespondtothedesignof

the transmitter provided.

1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in

neutral position

2. Drive forwards, slowly pull the throttle/brake lever towards the handle

3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away

from the handle without stopping

4. Driveforwardsandthengointoreverse(waitbrieybetweenthechange(approx.1-2seconds)andleavethe

throttle/braking lever in its neutral position!)

  Waitbriey

