User manual

a) Installing the Receiver Aerial

Figure 1

Modernremotecontrolsystemsin2.4GHztechnologyonlyrequireshortaerialsatthetransmitterandreceiverfor

secure operation. Only the few centimetres without insulation are the receiver aerial. The remaining part of the aerial

cable serves as supply/extension so that you can pull an aerial from a body.

Forsafereception,itisentirelysufcientforthelastthreecentimetresofthereceiveraerialtoprotrudefromthehull

asfaraspossible.Forthis,pushthereceiveraerialthroughtheaerialopening(1)andinsertitintotheaerialtube(2).

Theninstalltheaerialtubeattheaerialopeningwiththesiliconetubeasshowningure1,item3.

Important!

 Theremotecontrolrangemaybereduceddrasticallyifthereceiveraerialisnotplacedcorrectly(e.g.ifthe

aerial is only in the boat's body). In this case, the model can no longer be controlled. Check that the receiver

aerial is placed correctly before every operation.