User manual

46
b) Programming the Speed Controller
• Switchonthetransmitter.Pullthethrottleleverintothe"fullthrottle"positionandholditthere.
• Connectthedrivebatterytothespeedcontroller(thethrottleleverisstillinthe"fullthrottle"position).First,thereare
twoshortsignalsounds,followedbyashortsoundsequence(melody)afterveseconds.Thethrottleleverstillhas
to be in the full throttle position.
• Afterthedescribedsoundsignals,thespeedcontrollerhasenteredprogrammingmode.Fourdifferentparameters
canbeset(seechapter11).
 Theseparametersarerepeatedinanendlessloop.Therstsettingoptionisprovidedforselectionwithonebeep.
Then the speed controller switches to the second setting option and signals this with 2 signal sounds, etc. to the
fourth setting option with 4 signal sounds.
 Thenthedescribedsoundsequence(melody)followsandtherstsettingoptionisofferedagain.Thesettingop-
tions available can be taken from the table at the beginning of chapter 11.
• Whenthefunctionthatyouwanttoprogrammeissignalledacoustically,movethethrottleleveratyourtransmitter
totheneutralposition(motoroff).Thesoftwarenowswitchestotheselectedfunctionandreportsthiswithasignal
sound. Leave the throttle lever in the neutral position.
• Thereareuptoeightsettingoptionsforeachfunction(seetable).Thesesettingoptionsareindicatedwithsignal
soundsagain.Eachsettingisacousticallyreportedbytheassignedsignalsequence(numberofshortandlong
sounds)(anotherendlessloop).Thesignalsoundsthatcauseeachfunctionchangecanbetakenfromthetableat
the beginning of chapter 11.
• Whenthecorrectsettingissignalledbysounds,putthethrottleleverintothefullthrottlepositionwhensavingthese
settings.Thelevermustbekeptinthispositionuntilthespeedcontrollerconrmssuccessfulprogrammingbya
soundsequence(melody).
If you want to make additional settings, continue to keep the throttle lever in the full throttle position. Then the follow-
ing programme point is indicated. The further programming is performed as described.
• Ifyouwanttosaveyourprogramming(orcancelit)andnotstartdrivingatonce,disconnectthedrivebatterywith
thethrottleleverstillpulled(fullthrottleposition).
Alternatively, you may save your programmed settings and start driving immediately if you put the throttle lever in
theneutralpositionatonceafteraprogrammestepwasconrmedbythesoundsequence(melody).
 Thiswillbefollowedbyaconrmationsoundandthenumberofsignalsoundsthatindicatenormalinitialisation.This
is the number of sounds that the speed controller recognises according to the cell number of the driving battery or
thatareprogrammed(e.g.sixsignalsoundsfora6-cellLiPorechargeablebattery)+onesinglesignalsound.Then
you can start up driving again with the re-programmed speed controller.