User manual

9. Commissioning

a) Remove Car Body

Pull out the four retention clips and take off the car body upwards.

b) Installing the Receiver Aerial Cable

Uncoil the aerial cable completely and smooth it out care-

fully. Then insert the aerial cable through the attachment

at the vehicle from below and then through the included

aerial tube.

Plug the aerial tube into the respective holder at the ve-

hicle(seearrowinthegureontheright).Letanyexcess

aerial cable protrude loosely from the tip of the aerial tube.

The aerial cable may not be plugged into the holder yet at

delivery of the vehicle.

Never shorten the aerial cable! Never coil the

aerial cable! This greatly reduces the range!

c) Conguring the Speed Controller

Thespeedcontrollerhastwojumperstocongurethedri-

ving function and the rechargeable battery type.

Jumper „Reverse“ (A): This switches reverse driving off

(„Disable“) or on („Enable“).

Jumper „Battery“ (B): Sets what sort of drive battery is

connected to the speed controller (LiPo or NiMH).

Important!

If you use a LiPo drive battery but set the re-

chargeable battery type to NiMH, the rechar-

geable battery will be deep discharged and

destroyed.

Therefore, always set the proper rechargeable battery type before operating the vehicle.

The setting „Lipo“ causes the speed controller to reduce the motor power to 50% when the battery voltage drops

below 6.5 V.

The speed controller switches off the motor below a battery voltage of 6.0 V. This way, the LiPo drive battery is pro-

tected from harmful deep discharge.

Forthesetting„NiMH“,themotoroutputwillbereducedatarechargeablebatteryvoltageoflessthan4.5V;themotor

will be switched off if the battery voltage drops to under 4.0 V.