User manual

8. Commissioning

a) Remove Car Body

Removethesafetyclipsofthecarbodyrstandthenliftitfromthechassis.

b) Installing the Receiver Aerial Cable

Put the of/off switch (A) for receiver to the "OFF" posi-

tion.

Guide the aerial cable through the enclosed aerial

tube and plug it into the holder (B) next to the re-

ceiver box (C).

If the cable is still inside the receiver box, loosen the

screws of the lid of the receiver box and remove the

lid.

Guide the aerial cable through the corresponding

opening of the receiver box.

Our tip: Protect the receiver from strong vibrations by

wrapping it, e.g. in a little foam.

Then close the receiver box.

For best range, the aerial cable must protrude from the vehicle vertically.

Never shorten the aerial cable! Never coil the aerial cable! This greatly reduces the range.

c) Inserting Receiver Battery into the Vehicle

Open the battery box (A); the lid is attached with two

clips.

In the battery box, there is a two-pin red BEC con-

nection that comes directly from the on/off switch of

the receiver box.

Connect the receiver battery to the BEC connection;

observe correct polarity (red cable = plus/+, black

cable = minus/-).

Put the receiver battery in the battery box and close

the battery box again.

Our tip: fasten the receiver battery in the battery box,

e.g. with a pierce of hard foam or foam material.

Figure 1

Figure 2