User manual

d) Inserting Batteries / Rechargeable Batteries into the Transmitter

Openthetransmitter’sbatterycompartmentandinserteitherbatteriesorfullychargedrechargeablebatteries.Ob-

servecorrectpolarity(plus/+andminus/-),seelabelonthebatterycompartment.Closethebatterycompartment

again.

Observe the enclosed operating instructions for the remote control system.

e) Taking the Transmitter into Operation

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.

Ifthetransmitterhasadualratefunction,deactivateitorsetittounlimitedsteeringdeection.

Observe the enclosed operating instructions for the remote control system.

f) Inserting the Drive Battery into the Vehicle

Attention!

The drive battery must not be connected to the speed controller yet. Set the right battery type at the speed

controller (see chapter 9. c). Then switch on the transmitter, see chapter 9. d) and 9. e).

Important!

This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery

7.4V)orNiMHdrivebatterywith6cells(nominalvoltage7.2V).

 Whenusingadrivebatterywithmorecells,thereisadangerofrefromoverheatingofthespeedcontroller.

Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). A wrong cell

number will damage the sound generator. Loss of guarantee/warranty!

Remove the bracket (A) of the battery holder by pulling out

the two safety clips (B) and then pulling out the bracket

upwards.

The sound generator is glued to the top of the bracket.

Therefore, take off the bracket carefully to avoid damage

to the sound generator cable and to prevent the sound

generator from accidentally coming loose from the brack-

et.

Now insert the drive battery so that the connection cable of the rechargeable battery points backwards towards the

rear of the vehicle. Otherwise, the connection cable could impair the steering mechanism in its function.

Put on the bracket of the battery holder again and attach it with the safety clips removed in the beginning.