User manual

The vehicle does not reverse.

• Thejumper"Reverse"canbeusedtoswitchoffreversing.Intheposition"Enable",reversingison.Intheposition

"Disable", it is off. Observe chapter 9. c).

• Betweenswitchingfromforwardtoreversedriving,thethrottle/brakeleveratthetransmittermustbeintheneutral

positionbriey.Ifyoumovethethrottle/brakeleverfromforwardtoreversewithoutabreak,thebrakewillbeacti-

vated; the vehicle will not reverse!

The steering is not functioning or is functioning incorrectly, steering deection at the vehicle insufcient

• Ifthetransmitteroffersdualratesettings,checkthesesettings(observetransmitter’soperatinginstructions).Ifthe

dual rate setting is too low, the steering servo will no longer react.

• Checkthesteeringmechanicsforlooseparts;e.g.checkiftheservoarmisproperlyattachedtotheservo.

The motor sound of the motor sound simulator does not match the driving function.

• Programmetheneutralandfullthrottlepositionsatthemotorsoundsimulatoragain.

• Ifthemotorhasbeendisconnectedfromthespeedcontroller(e.g.formaintenance),swapthetwomotorcables.

• Ifthemotorsoundsimulatordoesnotemitanysoundatreversing,ensurethattheleveratthetransmitterisonly

releasedduringprogrammingafterthemotorsoundsimulatorhasconrmedtheendofprogrammingbyalong

signal.

The motor sound of the motor sound simulator is too loud or too low.

• Usethebutton"+"atthemotorsoundsimulatortoincreasethevolume;usethebutton"-"toreducethevolume.